Double Sided Polyethylene Foam Tape S1822 by Tenacious Tapes. Adhesive tape comparable to Tesa 60402 Tape, Nitto 5711, Husky 7032, PPC 580 or Stylus 5611 Tape. Order online from exclusive approved supplier Wayout Evacuation Systems.
Roll Size: 6mm to 1250mm in 10, 33 and 66 Metre Lengths
Adhesive: Acrylic Modified
Description: Black Polyethylene closed cell foam coated with pressure sensitive modified acrylate adhesive on both sides. Easy remove green silicone coated polyethylene release liner. Offers very good adhesion on difficult substrate surfaces.
Application: For constructional fitting & installation of a wide variety of materials including metals , glass, plastics & ceramics. Durable adhesion of signs and trims, letters and plastic moulded parts. Also automotive industry uses.
|Adhesion Power||FINMAT-TM1 on Stainless Steel one side covered with 50um polyester film|
|1 minute:||18 N/25mm|
|20 minutes:||18 N/25mm, foam tear|
|24 hours:||18 N/25mm, foam tear|
|Shear Strength||FINAT-TM8 on Stainless Steel one side covered with 50 um polyester film|
|Service Temperature:||-40°C to 80°C|
|Storage Temperature:||15°C to 25°C|
|Shelf Life:||24 Months at 20ºC 50% RH|
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 15ºC and 25ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
Note: The above figures represent average values. Actual figures can vary. The selection and application of a tape is the responsibility of the buyer. Tape should be stored at room temperature and should not be exposed to sunlight. We reserve the right to make changes without notice to our products and specifications.