Roll Size: 6mm to 1000mm in 50 Metre Lengths
Adhesive: Acrylic Modified
Description: Black Polyethylene closed cell foam coated with high coat weight pressure sensitive modified acrylic adhesive on both sides. Easy remove Red silicone coated polyethylene release liner. Offers very good adhesion on difficult substrate surfaces. The foam carrier at 0.50mm offers good adhesive wet-out whilst affording a small design gap between the two surfaces being bonded.
Application: For constructional fitting & installation of a wide variety of materials including metals , glass/mirrors, plastics & ceramics. Durable adhesion of signs and trims, letters and plastic moulded parts/profiles. Also auto industry uses.
|Foam Density:||200 kg/m3|
|Elongation at Break:||250%|
|Adhesion to Steel:||12.2 N/cm|
|Rolling Tack, Ball No.:||20|
|Service Temperature:||-40°C to 80°C|
|Storage Temperature:||15°C to 25°C|
|Shelf Life:||24 Months at 20°C 50% RH|
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 15ºC and 25ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
The above figures represent average values. Actual figures can vary. The selection and
application of a tape is the responsibility of the buyer. Tape should be stored at room
temperature and should not be exposed to sunlight. We reserve the right to make changes
without notice to our products and specifications.