Roll Size: 6mm to 930mm in 33 Metre Lengths
Adhesive: Acrylic Foamed LSE
Description: A White 0.6mm Foamed Acrylic Tape designed for applications where a high initial tack and very high permanent bond is required. It has a high performance foamed acrylic adhesive coated both sides with a special low surface energy (LSE) acrylic adhesive. It is plasticiser and UV resistant, giving good ageing properties. It is on a green plastic release liner suitable for die cutting.
Application: For structural bonding of metals and plastics. Typical applications include: signage, display, shopfitting, trim mounting and badge/nameplate mounting. Particularly for applications bonding dissimilar materials where differential ex-pansion and contraction may be encountered.
|Elongation at Break:||1000%|
|180° Peel adhesion:||After 15 Mins @ 23ºC Stainless Steel 15.9 N/cm|
After 24 Hours @ 23ºC Stainless Steel 17.0 N/cm
After 24 Hours @ 23ºC Polypropylene 14.9 N/cm
|Service Temperature:||-30°C to 90°C|
|Short Term Temperature:||100°C|
|Shelf Life:||12 Months|
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 15ºC and 25ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
The above figures represent average values. Actual figures can vary. The selection and
application of a tape is the responsibility of the buyer. Tape should be stored at room
temperature and should not be exposed to sunlight. We reserve the right to make changes
without notice to our products and specifications.